Filter
Top Products
EN 27
Repeat Playback
START REPEAT
1
Press and hold PLAY (until " " blinks on the front
display panel) during playback, then release.
● The entire tape is played back 50 times.
STOP REPEAT
2
To stop, press STOP at any time.
NOTE:
Pressing
PLAY
,
REW
,
FF
,
PAUSE
or
TIME SCAN
™
or
£
also stops Repeat Playback.
Tape Position Indicator
The Tape position indicator
appears on screen when, from the
stop mode, you press FF, REW, or
use the TIME SCAN SHUTTLE
ring, or perform an Index Search
or Instant ReView. The position of
" " in relation to "B" (Beginning)
or "E" (End) shows you where you
are on the tape.
NOTES:
●
"SUPERIMPOSE" must be set to "ON", or the indicator will not
appear (
੬
pg. 23).
●
It may take a few seconds for the Tape Position Indicator to be
displayed.
COUNT 0:33:27
BE
+++
Next-Function Memory
The Next Function Memory “tells” the VCR what to do after
rewinding. Before continuing, ensure that the VCR is in stop
mode.
a– For Automatic Start Of Playback After Tape Rewind . . .
. . . press REW, then press PLAY within 2 seconds.
b– For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press POWER within 2 seconds.
c– For Automatic Timer Standby After Tape Rewind . . .
. . . press REW, then press TIMER within 2 seconds.
NOTE:
It is not possible to select the Automatic Timer functions if the
cassette's record safety tab is removed.
SP
VCR
RESET COUNTER TO ZERO
1
Press C.RESET.
NOTE:
By pressing the
DISPLAY
button, you can change the
display to show the counter reading, channel number,
clock time or tape remaining time. (Channel number is
not displayed during playback.)
Counter Reset
Instant ReView
At the press of a button, you can power up your VCR, rewind the
tape and begin viewing the most recently recorded or timer-
recorded program.
ACTIVATE INSTANT REVIEW
1
After ensuring that the Timer mode is disengaged, press
REVIEW.
● The power comes on and the VCR rewinds to the index
code indicating the start of the last timer-recorded
program, then begins playback automatically.
● You can access a program 2–9 index codes away
from the current position on the tape. If, for example,
you have 5 programs recorded and you want to
watch the third one, press REVIEW three times.
● If necessary press REW or FF when play starts to
search visually to find the very beginning of the
desired program.
● If the tape is already rewound when REVIEW is
pressed, it will play the tape from the beginning. It
will not fast forward to an index code.
● The Instant ReView function will also operate if the
VCR's power is on.
Index Search
Index codes are placed on the tape at the start of each
recording. You can find and automatically play back from the
start of any recording using the Index Search function.
START SEARCH
1
While the tape is stopped, press TIME SCAN ™ or
£.
ACCESS DISTANT CODE
2
To access a recording 2–9 index codes away, press
TIME SCAN ™ or £ repeatedly until the correct
number is displayed on screen (only if "SUPERIMPOSE"
is set to "ON" (੬ pg. 23). Playback begins automati-
cally when the desired recording is located.
● If necessary press REW or FF when play starts to
search visually to find the very beginning of the
desired program.
NOTE:
An index code is not placed on the tape when recording is
paused and then resumed.