Filter
Top Products
58 EN
123
456
7
89
0
2
4
1
3
JOG
SHATTLE
+
−
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you wish to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your VCR as the recorder.
Insert Editing
EDITING (cont.)
NUMBER "0"
MAKE CONNECTIONS
1
Connect the player's VIDEO OUT or S-VIDEO OUT
and AUDIO OUT connectors to your VCR's VIDEO IN
or S-VIDEO IN and AUDIO IN on the front panel.
SET INPUT MODE
2
Press the NUMBER key "0" and CH so that "F-1"
appears in place of a channel number.
● Be sure to select the correct FRONT AUX INPUT
("VIDEO" or "S-VIDEO"). (To select the correct AUX
INPUT, follow steps 4 – 6 from the "Edit From A
Camcorder" section ੬ pg. 54).
LOCATE END POINT
3
Load the recording cassette into your VCR, and play it
back to determine the edit-out point (the end of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or pressing TIME SCAN ™£
and PAUSE.
● To use the JOG dial/SHUTTLE ring, first press the
JOG/SHUTTLE button on the remote control so that
the button lights up.
RESET THE COUNTER
4
Press C.RESET to change the counter display to
"0:00:00".
LOCATE START POINT
5
Determine the edit-in point (the beginning of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or pressing TIME SCAN ™£
and PAUSE.
● Be sure to engage the Still mode at the edit-in point.
Before insert editing
After insert editing
Source tape
Recorded tape
Normal audio
track
Video/Hi-Fi
audio track
Player
Recorder
Your VCR
Another VCR
Audio/Video cable
(supplied)
PAUSE
Audio/Video signal
PAUSE
TIME SCAN
C.RESET
CH
JOG/SHUTTLE
SHUTTLE
JOG
TIME SCAN SHUTTLE
JOG