Filter
Top Products
MANUAL CLOCK SETTING TV OPERATION
You must set the date and time manually for timer recordings, ON/OFF Timer and Daylight Saving Time If
the AUto Clock process did not _ them correctly,
EXAMPLE: Setting the clockto _8:30AM', 23th (SAT) October, 1999.
ill tose, thosYsTE.
SET-Up option, then press the ENTER button.
SET<-
-"(d_kTERMENU)
Press the SET + or - bulton to seleut the CLOCK
SET option, then press the ENTER button,
SET+
SET-
_SET
i ST_VJ_ T_
press the SET + or- budcn
to setthe month,then press
the ENTER button.
SET÷
Sat the day, year and time
as instop 3.
SEt-+
Aftersetting the clock,date an_ time"_
startsfunctioningautomatically.
NOTE: • After a power lallure or disconnection of the power plug, the time display willbe lost. In this case, set the
present grne again iftheAuto Clock did not set correctly.
• If youwant toconect the digitswhile setting, press the CANCEL buttonuntil the item youwant to correct,
then press the SET+ or - buttonto correct the desired setting.
16
U TOtom on the TV/VCR,
pressthe POWER button.
Adjust tbe voiome leval bypressing the VOLUME + or -
button. The volume Levelwill
be indicated on the screen bygreen
bar.AS the volume level increases,
so do the number of ber_Ifthe
volume decreases, the number of
green bar also decreases.
Set the TV/CA'rV menuoptionto the appropriate
position.(See page 21 .)
[ CTVATV_VHFL_I"FTvCChhaannnnt/_sI
VHF/UHF/CATV CHANNELS
1"/ CAW
VHF VHF
2-13 2-13
UHF STD/HRC/IRC
14-69 t4-36
(A) (W)
37-59
/(_'_'-.=J.,_ I I (_'_)=_(zzz_I
95-99
(A-S)(A-l)
100-125
(SA)
_ Pressthe DirectChannel selec0orlbuttonsto selectthechannel.
W mode direct channel indention -
/
When the W/CAW menuoptionisin the TV position,ell channelscan be instantlyselectedbyusingtwo
buttons, (forexample, to selectchan,lts2, pre_.s"0", then "2".If youpressonly"2",channelselectionwillbe delayed for/
a few seconds.)For channels10andabove, pressthe2 digitsinorder. 0 1 2
When theTV/CATV menuoptionis in theCAW portion, channelsP.anbe sts_t_d as to_iows:
TO SELECT CATV CHANNELS:
1-9 Press "0"twice, than1-9 as needed. (Example,to select channel 2, press002.)
10-12 Press "0",then the remaJning2 digits.(Example, toselectchannel t2, press012,)
100-125 Press the3 digitsin orbed,(Example, toselectchannel 120, press120.)
NOTE FOR CHANNELS 1-12:
If only 1 or 2 buttons are pressed, the corresponding channel willbe selected in 2 seconds.
NOTE: • Ifa channel with no broadcast is selected, the sound will automatically be muted.
• If a stationbeing viewed stops broadcasting, the "IV willautomatically shutitselfoft after 15 minutes.
17