Filter
Top Products
Preparations
8
XV-C5SL/LET0227-003A/English
Prep
arations
Using the remote control unit
To install batteries
Open the compartment cover, and place the two
supplied R6P (SUM-3)/AA(15F) batteries in the remote
control unit according to the polarity markings (“+” and “–
”) inside the compartment. Then replace the cover.
The batteries will last about six months with normal use.
If the functions of the remote control unit become erratic,
replace the batteries.
Precautions of the safe use of batteries
Observe the following precautions for the safe use of
batteries. If they are used improperly their lives will be
shortened, they may burst or their contents may leak.
• Remove the batteries from the remote control unit if it is
not going to be used for a long period of time.
• Remove dead batteries and dispose of them properly.
• Never leave dead batteries lying around, take them
apart, mix them with other refuse, or throw them into an
incinerator.
• Never touch liquid that has leaked out of a battery.
• Do not mix new and old batteries, or batteries of
different types, when replacing them.
Remote sensor
Point the top of the remote control unit toward the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
The illumination lamp flashes in a few seconds when the
unit receives the remote signal from the remote control
unit.
Remote sensor
Illumination lamp
XV-C5SL(B).book Page 8 Friday, February 21, 2003 10:59 AM