Filter
Top Products
15
MENU CONTENTS
You can adjust (set) the following items on the
menu screen. Each adjusted (set) value is
automatically memorized.
The values inside [ ] are the factory presets.
1 CONTRAST (Picture Contrast)
Adjusts the picture contrast. Decreasing the
value lowers the contrast, and increasing the
value raises it.
Adjustable range: –30 to +30 [0]
2 BRIGHTNESS (Picture Brightness)
Adjusts the picture brightness.
Decreasing the value makes the picture darker,
and increasing the value makes it brighter.
Adjustable range: –30 to +30 [0]
3 SHARPNESS (Picture Sharpness)
Adjusts the picture sharpness.
Decreasing the value makes the picture softer,
and increasing the value makes it more sharp.
Adjustable range: –30 to +30 [0]
4 CHROMA (Picture Chroma)
Adjusts the picture chroma.
Decreasing the value makes the picture lighter,
and increasing the value makes it deeper.
Adjustable range: –30 to +30 [0]
5 PHASE (Picture Phase)
Adjusts the picture phase.
Decreasing the value makes the picture more
reddish, and increasing the value makes it more
greenish.
Adjustable range: –30 to +30 [0]
* PHASE can be adjusted only with NTSC
video signals.
* PHASE is not displayed when PAL is
selected.
6 COLOR SYSTEM (Color System)
Displays the color system (NTSC or PAL) used
by the video equipment.
* COLOR SYSTEM is not displayed when TV
is selected.
7 POWER SAVE (Power Save)
With the power save function set to ON (active),
the monitor automatically enters standby mode
when no video signal is input. When the power
save function is active, the POWER indicator
blinks in green. When a video signal is input, the
power save function becomes inactive and the
monitor is restored to normal operation.
Pressing any buttons on the front operation
panel also sets the power save function to
inactive. [OFF]
* The power save function becomes active
when no video signal is input for over 30
seconds.
8 COLOR SW
Turns the picture into black and white for
checking the white balance. [ON]
The following items are displayed only when TV
is selected:
9 CH STATUS (Channel Status)
With CH STATUS set to OFF (inactive), the TV
channel is not displayed when it is selected.
[ON]
0 CH SEARCH START (Initiate Channel Search)
The monitor automatically searches for
broadcast stations (VHF/UHF) it can receive and
memorizes them.
(Also refer to SETTING TV CHANNELS on page
17.)
* The monitor memorizes channels in
ascending order.
* When you move the monitor into an area
that receives different channels, perform
CH SEARCH START again.
! CH SKIP ON (Channel Skip ON)
Deletes a channel set in CH SEARCH 0. Select
the channel to be deleted and perform CH SKIP
ON.
@ CH RESET ON (Channel Reset ON)
Resets all TV channels set in 0 CH SEARCH
START to their factory presets. After performing
channel reset, all TV channels (VHF: 2 – 13 /
UHF: 14 – 69) can be tuned.
NTS