JVC TM-L450TU Home Theater Screen User Manual


 
17
S (cont’d)
4 Adjust CHROMA (picture chroma) or PHASE
(picture phase).
When an NTSC color bar signal is input:
1 Adjust CHROMA (picture chroma) so that the
blue bars on the left and right side of the
screen have the same brightness.
2 Adjust PHASE so that the two blue bars at
the center of the screen have the same
brightness.
3 Repeat procedure 1 and 2 so that all four
blue bars on the screen have the same
brightness.
When a PAL color bar signal is input:
Adjust CHROMA (picture chroma) so that the
blue bars on the left and right side of the screen
have the same brightness.
* Refer to BASIC MENU OPERATION on
page 14 for the adjustment procedure.
5 After adjustment is complete, press the BLUE
CHECK button again to turn the blue check
function OFF (inactive).
SETTING TV CHANNELS
This monitor is factory-preset to tune all VHF (2 to
13) and UHF (14 to 69) TV channels.
To perform the following, press the TV button to
select TV.
When you want to reset the memorized TV
channels, perform CH SEARCH START (initiate
channel search) from the menu screen (refer to
pages 14 and 15). The monitor automatically
searches for broadcasting stations (VHF/UHF) and
memorizes them.
You can also delete channels you do not want to
watch. Select the channel to be deleted and
perform CH SKIP ON (channel skip ON) from the
menu screen (refer to pages 14 and 15).
* Channels deleted by CH SKIP ON (channel skip
ON) cannot be tuned again. If you want to tune
them, perform CH RESET ON (channel reset ON)
from the menu screen to tune all VHF (2 to 13)
and UHF (14 to 69) TV channels.
* In areas where the radio wave reception weak,
searching for TV channels will not function well.
In this case, perform CH RESET ON (channel
reset ON) from the menu screen to tune all VHF
(2 to 13) and UHF (14 to 69) TV channels.