JVC TM-L450TU Home Theater Screen User Manual


 
19
Problems
The screen size is
small.
There is no TV
reception.
Points to be checked
Is the screen size set to UNDER?
Is an antenna connected to the
monitor?
Was the monitor moved to an area that
receives different channels after CH
SEARCH START (initiate channel
search) was performed?
Measures (remedy)
Set the screen size to OVER.
Connect the TV antenna cable.
Perform CH SEARCH START each
time the monitor is moved to an area
that receives different channels so
that the monitor can memorize the
new broadcast stations. Otherwise,
perform CH RESET ON (channel
reset ON) to tune all TV channels.
There may not be a solution to the following problems, although adjusting the antenna or taking
measures against interfering equipment may improve the situation somewhat.
The screen appears snowy and noise is heard. (Snow)
Is the antenna connected properly?
Has the antenna cable been cut or loosened?
Has the antenna orientation been changed or is the antenna broken?
The image is displayed two or three times on the monitor. (Ghosting)
This may be caused by mountains or buildings. Also, if the broadcast antenna is located nearby,
the TV transmission the monitor receives directly from it may affect the picture.
Spots are displayed and noise is heard. (Interference)
This may be caused by interfering radio waves generated by dryers, automobiles, motorcycles or
fluorescent lights.
Stripes are displayed and noise is heard. (Radio Interference)
This may be caused by radio interference generated by radio stations, personal computers, AV
equipment or microwave ovens.
The following are not malfunctions:
The monitor emits a strange sound when the room temperature changes suddenly. This is only a
problem if an abnormality appears on the screen as well.
If two or more monitors are operated next to each other, their images may shake or be distorted. This
phenomenon is due to mutual interference; it is not a malfunction. Move the monitors away from each
other until the interference disappears or turn the power off on any monitor that is not being used.
If a magnet or speaker is placed close to the monitor, the picture may shake. This is caused by the
magnetic effect and is not a malfunction.
When the monitor is turned ON, the sound of a running motor may be heard. This is the cooling fan and
is not a malfunction.
When playing back a video tape, the upper edge of the picture may be distorted. This is caused by
skew distortion and is not a malfunction.
Vertical stripes may occur on a dark picture. This is caused by quantization noise (noise which occurs
when a picture is digitized) and is not a malfunction.