Filter
Top Products
Remote Control Command Set
10
Remote Control Command Set
The remote control features 2 command sets, making it possible to
operate 2 receivers independently of each other in one room (not
together with a twin receiver).
Note: For this purpose, program one receiver on the command set 1 and the
second receiver on the command set 2.
Switch on receiver 1 and switch off receiver 2 with the power switch.
Press and hold the
button.
Enter "901" with the number buttons.
To adopt the code, press the
button to switch receiver 1 to
standby and then switch off the device at the power switch.
Switch on receiver 2.
Press and hold the
button.
Enter "902" with the number buttons.
To adopt the code, press the
button to switch receiver 2 to
standby and then back into operation. Now switch on receiver 1 again.
Press and hold the
button.
Enter "903" with the number buttons.
When carrying out the first two settings, the remote control must be
directed at the respective receiver (when switched on).
By pressing the
button, you can now switch between the two
command sets A and B (toggle function) and alternately operate both
receivers.
Command set 1 is always active as the on-delivery setting.
If you are operating only one receiver and the active command set is
switched over by mistake so that this receiver can no longer be
operated, the remote control can be easily switched back to command
set 1. For this purpose, follow the procedure described above.