Filter
Top Products
Switching On for the First Time
15
Switching On for the First Time
The first steps
• Make sure that you have made all connections correctly.
• Connect the receiver to the mains power supply.
• Switch on the receiver by pressing the power button at the front
of the unit.
The operation indicator LED on the front panel lights red, the receiver
is now in standby mode.
Switch on the receiver by pressing the
button on the remote
control.
• The green LED lights and the receiver assumes reception mode.
The green LED at the front of the receiver provides confirmation
every time a button is pressed on the remote control.
You will see the factory preset channel on your TV screen. An
information bar indicating the channel provider, the time, the timer
settings, the channel status and the channel title will be displayed in
the bottom section of the screen provided the corresponding data are
transmitted. The number of the channel memory appears in the LED
display.
The red standby indicator goes out.
You can now receive the TV and radio channels preset at the factory
and select them by pressing the buttons. Press the
and
buttons to select radio channels. Press the or
button to return to TV channels.
Refer to the section "Channel lists – TV/radio" for information on how
to set up and save other TV and radio channels.
The reception status last set always reappears when the receiver
is switched on.
If the message "bad or no signal" appears on the screen in addition to
an on-screen display indicating the channel last received, you will
need to check the system installation and/or the receiver settings. If
this problem only applies to individual channel slots, the problem may
be due to an interruption in the transmission signal.
Factory setting of the receiver
Before you change the basic settings of your receiver, make a note of
the settings in the form provided at the end of this User's Guide. In this
way, you will be able to restore the original settings at any time.