Filter
Top Products
Setting System Parameters
54
Network selection
You can now select the required positions with the buttons:
• Depending on whether a network is already set, after pressing the
or button in the required position you will be asked whether
you wish to delete or add the network. If add is selected, the
cursor will jump to "Operation".
• Under "Operation" use
or to set whether you have an active
antenna requiring power supply from the receiver.
• Under "Standby" enter whether the power supply for the antenna
is to be switched on or off in standby mode.
Factory setting
In this position, you can reset all settings to the factory settings by
pressing
. The factory settings need not necessarily correspond to
the settings required for your receiving system! After the reset, you
may have to carry out the entire set-up procedure necessary for your
receiving system.
Software and channel list update
Thanks to digital technology, the software and channel list of your
receiver can be updated in signal reception mode. The software
download submenu will inform you whether new software or a new
channel list is available. The only precondition is that your receiving
system is aligned and set to a service channel.