Filter
Top Products
Installation
6
Installation
• First of all, connect your receiver to the TV set and the antenna
installation.
• Switch on the TV set.
• Select the AV programme position for the receiver connection.
• Now
connect the receiver to the wall outlet.
• Switch on the receiver by pressing the red
key on the remote
control (stand-by). The following is displayed on the screen:
• Use the
keys to scroll the selection cursor to the line
'Language' and select the desired language with the keys
. Confirm your entry with
.
• Use the
keys to scroll the selection cursor to the line
'Active Antenna' and select the desired setting with the keys
. Confirm your entry with
(see pages 15 and 17).
• Use the
keys to scroll the selection cursor to the line
'Start Search'. Confirm your entry with
.
We recommend you had the entries now saved by the receiver.
Now, a search is carried out and the receiver is in the basic setting.
The on-screen display informs you on the next steps.
The first programme of the channel list is displayed on the screen,
below, a bar is displayed, informing on the programme provider, time,
timer settings, programme status and programme name, provided that
this information is broadcast by the programme provider. The LED
indicates the programme memory number.
The reception status last set will be called up each time you
switch on the receiver!
If 'bad or no signal' is displayed on the screen together with the
programme last received, check whether the installation is in order
and the settings of the receiver are correct. If only a few programmes
are affected, this may mean a signal failure on the part of the
programme provider.
Please check the time as to daylight savings time and wintertime!