Filter
Top Products
119
Receiver to Receiver Data Transfer
Your receiver is able to receive data from another receiver via its RS232
port. For this, the two receivers are interconnected via a so-called
zero-modem cable. The transmitting receiver is the “master”, and the
receiving receiver is the “slave”.
Preparations
The master and slave are both switched on. Then the RS 232 ports of
the two receivers are interconnected by a zero-modem cable.
Channel List Download
Master:
Select “System Setup” - “STB Management” - “Transfer Channel Data”.
Press the
button. Use the
buttons to select “OK” and start the
download by pressing
. The master searches for the slave and, once
it has found it, automatically begins downloading the channel list. The
following display appears: “Channel data being transmitted”.
Slave:
The following display appears: “Receiving data”. Once all the data has
been received, first remove the zero-modem cable and then switch the
receiver off and back on again at the power switch (hard reset). You can
now use the new channel data.
Firmware Download
Not yet available in the current software version.
Only possible between two UFS 821 receivers!!!!