Filter
Top Products
43
User Preference
Use the
buttons here to select the default recording time. If
you forget to stop a recording you started manually, it is automatically
stopped by the receiver when the default recording time elapses. You can
choose between 30 minutes and 4 hours, in 30 minute increments.
Default Record Duration
When you have made all the settings, press
to save them.
Save
On this menu use the
buttons to set the time at which you want
the UFS 821 to update the EPG data. The receiver (which must be
in Standby mode) switches on from Standby, updates the data and
then returns to Standby. Scheduled recordings do not affect this; the
receiver then carries out the update automatically later when recording
is finished.
EPG Grabbing Setup
On this menu you can use the
button to delete the stored tvtv data.
You can then have the UFS 821 update the tvtv data at the selected
time or press
to switch your receiver to Standby. The receiver
automatically starts updating the tvtv data. The progress of the tvtv
data update is indicated on-screen. After updating the data, the receiver
automatically switches back to Standby. You can now restart the receiver
by pressing the
button.
Invalidate tvtv-Data
Use the
buttons here to select whether to enable on-screen
display of the advanced recording settings on starting (press
button) or not. If you select “Disable”, in manual recording mode, time-
shift recording is automatically started (see “Recording” section). Other
recording modes are then excluded.
Prompt on Recording