Filter
Top Products
7
CONNECTION AND SET-UP
This section is intended specifi cally for specialist dealers. You only need to refer to it if you are
carrying out the installation yourself. The “Connection Diagram” section provides a sample
confi guration.
Do not connect the unit to the mains until all installation work has been properly carried out.
Refer to the information in the “Safety Instructions” section.
ANTENNA CONNECTION
DVB-T TV was developed to enable you to receive a good quality TV picture anywhere,
provided the signal is strong enough. Connect the receiver either to your conventional stand-
alone or community antenna through which you receive all VHF/UHF signals, or use an antenna
developed for DVB-T (such as the Kathrein BZD 30 for direct reception indoors or the BZD 40 for
outdoors). DVB-T TV cannot work miracles however; you must be receiving a good quality signal.
You may encounter problems in concrete buildings if you are using only an indoor antenna.
TV CONNECTION
Connect the UFT 671si (TV Scart socket) and the TV set using a Scart cable. If your TV has a stereo
feature, you can receive the sound in stereo via the Scart connection.
If you are using (or have to use) an active antenna - that is, an antenna with a pre-amplifi er,
you can power it from the receiver‘s antenna input. The default setting in the receiver is
“OFF”, to prevent any damage from occurring. Be sure to use an antenna designed for
a 5 Volt supply (such as the Kathrein BZD 30).
DOLBY CONNECTION
The Dolby Digital data stream output (AC 3) is intended for connection to a Dolby digital system.
IR RECEIVER (ACCESSORY, NOT SUPPLIED)
The infra-red receiver allows you to place the unit in a concealed location. Connect the infra-red receiver
to the “IR REMOTE IN” socket and position it such that it has a visual connection to the remote control. On
the use of the external infra-red sensor, it should be ensured the receiver‘s internal infrared sensor is not
activated in parallel by the remote control, as otherwise the receiver will hang. You can place an order for the
infra-red receiver with our service centre (see page 40).