Filter
Top Products
TROUBLE SHOOTING
Symptom
Remedy
No picture.
Images appear distorted.
1. Buy a newer TV with these jacks.
2. You may try using your VCRs jacks but the color may be distorted due to macrovision
licensed DVD protection (against copying discs).
3. Talk to your dealer (or local TV repair shop) if they can sell you an RF adaptor which may be
able to convert the signals for inputting into the TVs RF input (antenna) jacks. However, your
results will never be as good as a new modern TV with proper input jacks.
1. Clean the disc.
2. See if the disc is defective by trying another disc (If disc is very badly scratched or dirty,
it will not play).
3. check if the DVD disc is for Region 1.
1. Check if the TV or VIDEO is switched on.
2. Check if the proper AV input is selected on your TV set video inputs (some TV sets have
3 or 4 different inputs).
3. Check the Audio / Video cables.
If faces seem stretched and too long, your TV shape may be adjusted to 16:9 ratio.
Please adjust it to 4:3 for better results or match to your TV type, see page 16.
If your TV set does not have Audio / Video
input jacks.
DVD
No Disc shows on left top corner.
The disc is upside down or a non-playable disc was inserted. Change the disc.
Damaged Disc shows on left top
corner.
Press the EJECT button and replace a good
USA standard disc into the player. This
player only plays NTSC region 1 DVD discs made for USA use.
This set will not play PAL or other foreign DVDs (due to legal reasons).
Door cannot open from the set.
Wait a few seconds, this function takes a little longer, also try the EJECT button on
the REMOTE control.
28
The subtitle or language is not what you
selected.
Go to page 15.
The icon appears in the left top corner. The feature or action you selected cannot be done at this time or with this disc.
Wrong Region Disc shows on left top
corner.
If a button is pressed too fast over and over, the signals may jam the circuits inside. To restore
to normal, press OPEN/CLOSE or EJECT or remove the AC power plug for 2 minutes and
reinsert to reset the circuits.
Picture is frozen
Do you connect your DVD player to your VCR? Please disconnect from VCR.
Picture is distorted.
Turn off screen saver by press any button on the REMOTE control.
Screen saver appears on TV screen.
Please reset the language to English by following Page 15.
Menu is in foreign language.
You cant copy most discs due to copy protection built into the disc.
1. When the disc is busy loading (or during play), the disc must stop spinning first, then
the tray will open. Please be patient, it may take over 30 seconds.
2. If you put a disc into the tray UPSIDE DOWN, the DVD player will try to read the data
but there will be no data to read. It may take as long as 40 seconds for the attempts to
finish and the door to open.
Can not copy discs to VHS video tapes.
Change the picture screen type, see page 16.
Disc will not eject.
Reset the REMOTE by removing the batteries and pressing a button for 2 minutes, then replace
the batteries.
Picture is too short.
REMOTE will not work.
IB-DVD-2002-WC-ZR-E-V1