Filter
Top Products
Basic Operations Lexicon, Inc.
3-6
(4) Editing a Program or Register
Once a Program or Register is loaded, you can edit it to
get exactly the effect you want. The simplest way to do
this is by changing the settings of the parameters
assigned to the faders and joystick on the V-Page,
which is available in Program, Register and Bank
modes.
For parameters assigned to faders:
• Touch the fader you want to change. When you
do, that parameter and its setting will be
highlighted in yellow on the Scribble Strip and will
appear, in larger lettering, on the Action Display.
Move the fader to get the desired setting.
• If you can’t move the fader in small enough
increments to get the precise setting you need,
get as close to that setting as you can, then press
the FINE ADJ key and adjust the parameter with
the fader in vernier mode. Press FINE ADJ again
to leave Fine Adjust Mode.
• You can move several faders at once.The settings
indicated on the Scribble Strip will change for all.
When you release the faders, the last one you
touched will be highlighted and appear on the
Action Display.
For parameters assigned to the joystick:
• Press the JOYSTICK Key on the LARC2, then
adjust the joystick until the Joystick Status Display
shows the desired settings (Fig. 3-6).
(5) Storing Your Edits
Your edits will stay in force until you change them again
or load another Program or Register. To save them for
future use, press the
STORE key. The STORE
key will blink to remind you
that the store operation is
pending.
• If you’ve been
editing a user-created
Register, the 960L
will highlight the
current Bank and
Register. If you wish
to replace that
Register with your
edited version, press
STORE a second
time to save your edit.
• If you've been editing a
factory Program, the
960L will look for the first Register Bank with space
available or the Register Bank you last stored to,
and the first empty Register within that bank.
• If you’d prefer a different Register Bank, press the
BANK key and enter the number of the desired
bank (or scroll to it with the Navigation Arrows).
• If you'd prefer a different Register, press the
REGISTER key and enter the number of the
desired Register (or scroll to it with the Navigation
Arrows).
• To Name a Register or Register Bank, press the
NAME soft button and follow the directions below.
• To add explanatory information to a Register or
Register Bank, press the INFO soft button and
follow the directions below.
• When everything (target Bank, target Register,
NAME and INFO) is the way you want it, press
STORE again, to save.
A Quick Guide to Operation, Continued
Figure 3-6 —
JOYSTICK STATUS Display
Figure 3-7 — Storing