Filter
Top Products
960L Owner’s Maunal Operations in Detail
The 960L’s Programs and Registers can be edited in
several ways:
• Changing the settings of the parameters with the
faders and joystick
• Adjusting input and output panning
• Adjusting input and output levels
• Assigning new parameters to any fader or to either
joystick axis
Edits stay in effect until a new Program or Register is
loaded, or can be saved as Registers. You cannot
overwrite factory Programs, but you can save edited
Programs as Registers. Registers, like Programs,
reside on disk and can be recalled anytime. They can
also be saved on floppy disk, for archiving or for copying
to a second 960L.
Editing Algorithms
A Program or Register becomes edited any time you
alter the current parameter settings with the faders or
joystick. To save these—or any other—edits, just press
the Store key, check to be sure the storage location is
correct, then press Store again.
Editing With the Faders
1) Use the Numeric Keypad or Navigation Arrows to
select the Edit page that contains the parameter you
want to change.
2) Check the Scribble Strip to find the parameter to
edit.
3) Touch the corresponding fader. That parameter will
be highlighted on the Scribble Strip and its name and
setting will appear in large characters on the Action
Display at the upper left of the screen.
4) Adjust the fader to the desired setting.
Fine Adjust
For some parameters, the range of possible values is
so large that the smallest possible fader movements
change the value too much.
To make fine adjustments, set the faders to the
approximate values you want, then press the FINE ADJ
Button.When this button is pressed, the faders all move
to the center of their travel, but their parameter settings
do not change. The faders then operate in a vernier
mode, with a limited adjustment range and far fewer
steps per inch of travel, so that full-range movement of
the fader will alter the parameter value only a little from
its coarse value.This makes it easy to tweak the setting
to the exact value you want.
On entering fine adjust mode, the Action Display says
"Fine Adjust Enabled". The centering of all faders is an
additional indication.
Pressing FINE ADJ a second time will return the
system to normal operation. The faders will return to
their appropriate full-range positions.
When in the Edit Algorithm Mode, to make fine
adjustments of a single parameter, simply touch the
appropriate fader to select the parameter, then use the
Increment/Decrement (+/–) buttons to get the setting
you want. Each press of these buttons will change the
parameter by its smallest possible increment.
Editing
4-9
Figure 4-13 — Algorithm Edit Screen with one fader parameter selected