LG Electronics 32-3DCH-UA CRT Television User Manual


 
PAGE 48
206-4071
Problem Solution
Cannot change channel status in menu. Installer menu item 028 Ch Overide is set to 000.
Set Ch Overide to 001 to allow access for channel status change.
Channel Preview menu does not appear. 2-5-5+ Menu procedure was not performed.
Channel Banks setup menu will not be available until 2-5-5+ Menu procedure is done.
And, item 028 Ch Overide is set to 001 to allow access for channel status changes.
Channel is blanked in all channel banks. Blanking a channel in one channel bank will make it blank in all channel banks.
Cannot tune in deleted channel Select a channel bank where the deleted channel number is set to ‘Normal Added’.
on Ch Preview menu. Direct enter the deleted channel number. Change to the bank you want to activate the
channel in. Select ‘Normal Added’ on the Ch Preview Channel Banks menu.
‘Inactive TV’ message appears TV is set up to display ‘Inactive TV’ message if all channels are ‘Normal Delete’ from
and then TV turns off. Channel Bank 4. Select another channel bank (Bank 1, 2 or 3) which will return TV to
normal operation.
Channel found in scan does not tune in Channel was deleted in currently selected channel bank. If banks were set up, premium
with Channel Up/Down. channels may only be available on another channel bank.
Select the channel bank where the channel is set to ‘Normal Added’. Or, direct enter
channel number then go to banks menu and select ‘Normal Added’.
If ‘Bank’ on Installer remote is pressed, Item 027 Hospital Mode in Installer menu is set to 0. Set back to default ‘2’ for
TV shows Aux sources selection menu. Channel Banks to appear with Bank or Source key presses.
Channel Banks Setup Troubleshooting
CH 011-001 NORMAL-ADDED
Enter -> Change
CC ->VCHIP Menu Ch. Preview -> Exit
CHANNEL PREVIEW - BANK 1
Channel Banks Setup Menu