Filter
Top Products
30
206-4096
There are three options for cloning a Master TV
Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the
pages that follow. As you perform cloning proce-
dures, be sure to complete each task as indicated.
If a procedure or step is omitted or not performed
completely, cloning may not work. At each step,
pay attention to ensure the TV screen shows the
proper message when cloning. If the message
indicated does not appear, there is a problem with
that step, and cloning may not be successful.
Warning: Copying a blank or incorrect
memory into a TV will cause the TV to
operate erratically or become inoperable.
Warning: Do not connect a clone pro-
grammer to a PPV card installed in the
Master or Target TVs, as this will damage
the clone programmer and the PPV card.
Installer Menu
Installer Menu item settings
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Option
Menu Language
Audio Language
Caption
Caption Mode
Digital Caption Options
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Time
Auto Clock
Manual Clock
Off Time
On Time
Auto Off (Sleep Timer)
Cloning Overview / Clonable Menu Features
Notes:
• Some menu options vary between analog and digital channels and Aux sources.
• The end user only has access to features that are available on the pillow speaker or the
user remote control if provided by the institution.
Clonable Menu Features
IMPORTANT CLONING INFORMATION
Before you begin cloning:
• Complete the Commercial Mode Setup procedure on pages 14
to 15.
• All equipment should be connected to power and turned ON.
• Learning and Teaching is only possible between identical model
TVs.
• Both the Master and Target TVs must be in Pass-through Mode.
• If using a USB memory device, ensure the USB device has been
formatted with FAT format.
• For both Master and Target TVs—If using a clone programmer,
ensure the TV signal source is either an Aux or TV (RF) source.
If a TV (RF) source, the TV must be tuned to an analog (not a
digital) channel.
• LT2002 only—Make sure the batteries in the clone programmer
are fresh. If batteries are removed, the clone programmer clock
time (if set) will be lost (see page 35 for information on the clone
programmer clock).
• Do not unplug the TV power cord or remove/disconnect the USB
memory device/clone programmer while Learning or Teaching,
as doing so may cause the TV to malfunction or harm the USB
device/clone programmer, respectively.