Filter
Top Products
9
Hookup and
Settings
Hookup and
Settings
Connections to Your TV and
Aerial
1. Remove the aerial cable plug from your TV set
and insert it into the aerial socket at the back of
the recorder.
2. Connect the RF. OUT jack on the recorder to the
aerial input jack on the TV using the 75-ohm
Coaxial Cable supplied (R). The RF. OUT jack
passes the signal through from the AERIAL jack.
3. Connect the EURO AV1 AUDIO/VIDEO scart jack
on the recorder to the corresponding in jacks on
the TV using the scart cable (T).
Caution
– Make sure the recorder is connected directly to the
TV. Tune the TV to the correct video input channel.
– Do not connect your recorder via your VCR. The
DVD image could be distorted by the copy
protection system.
Connecting to an Amplifier
Connecting to an amplifier equipped with two
channel digital stereo (PCM) or to an Audio/
Video receiver equipped with a multi-channel
decoder (Dolby Digital™, MPEG 2, or DTS)
1. Connect one of the recorder’s DIGITAL AUDIO
OUT jacks to the corresponding in jack on your
amplifier. Use an optional digital audio cable.
2. You will need to activate the recorder’s digital
output. (See “Audio Setup” on page 16-17).
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel
Audio/Video receiver that supports one or more of the
audio formats supported by your recorder (MPEG 2,
Dolby Digital and DTS). Check the receiver manual
and the logos on the front of the receiver.
Caution:
Due to the DTS Licensing agreement, the digital
output will be in DTS digital out when DTS audio
stream is selected.
Notes:
–
If the audio format of the digital output does not match
the capabilities of your receiver, the receiver will
produce a strong, distorted sound or no sound at all.
– Six Channel Digital Surround Sound via digital
connection can only be obtained if your receiver is
equipped with a Digital Multi-channel decoder.
–To see the audio format of the current DVD in the
on-screen display, press AUDIO.
– This recorder does not perform internal (2 channel)
decoding of a DTS sound track. To enjoy DTS
multi channel surround, you must connect this
recorder to a DTS compatible receiver via one of
this recorder’s digital audio outputs.
Rear of the recorder
T
ANTENNA
INPUT
Aerial
Rear of TV
L
R
AUDIO INPUT
VIDEO
INPUT
SCART INPUT
R
DIGITAL INPUT
COAXIAL
Amplifier (Receiver)
Rear of the recorder