Filter
Top Products
34
Phone Connection
Select Next and the Recorder attempts to dial out using the phone
line. If the dial-out is successful, the Choose Dial-up Number screen
appears.
Note If the dial-out is not successful, try the following: check to
your phone connections; check to see if there is a voice mail message
indicator (tone) on your phone; and make sure your telephone
conguration options are correct (do you need to dial a 9 for an outside
line, for example).
Choose Dial-up Number
A list of phone numbers that the Recorder can use to connect to the
Microsoft
®
Program Guide service is displayed. If more than one phone
number is available, select at least two phone numbers. The second
number selected in the list is a backup phone number in case the rst
number is busy or out of order. You can select up to ten numbers.
Warning Toll charges may apply if using a long distance number to
connect to the service. For more information, check with your phone
company.
Note The Recorder can connect to a network by using broadband and
download Guide listings by using a dial-up connection, at the same
time. The Recorder uses the most recent connection you have selected
in Setup to connect to the Internet.
1. While setting up a connection in the Setup Wizard, select
Use
Broadband.
2. Follow the steps in section
1a. Use Broadband.
Note If you have completed setup and need to switch to broadband,
you can change the connection type by selecting Start > Settings >
Phone and Network Setup.
3. Complete the Setup Wizard.
4. On the
Start menu, select Settings > Phone and Network Setup.
5. Select
Use Phone Line.
6. Follow the steps in section
1b. Use Phone Line.
2. Clock Setting
The clock for the Recorder can be set automatically (recommended)
or manually.
• Select Set Clock Automatically, and then select your time zone and
whether the area where you live observes Daylight Savings Time.
• If the automatic clock settings do not work correctly—such as the
clock is one minute behind or ahead—select Set Clock Manually.
You can set the clock manually after setup is complete by selecting
Settings > System Information.