Filter
Top Products
10
Automatic programming
Automatic programming of the TV set is started the fi rst time you switch it
on. Follow the menus.
First you have to select the menu language. Then you enter which anten-
nae you have connected to your TV set and in what country you are using
it. Then start the station search. The TV set searches for, saves and sorts all
programs which are receivable on your antenna system.
Then log in your video equipment, decoder and Loewe audio system with
the co.nnection wizard and connect these to the TV according to the dis-
played connection diagram. If you want to connect other equipment later,
you will fi nd information from page 22 onwards.
By pressing the OK button in the direction of the arrow you
select the setting ...
... and confi rm your settings with OK. You then go to the
next menu.
Back
You can repeat initial installation at any time, e.g. after moving house. Call
the index with the INFO button. Select the index item “Repeat initial opera-
tion“ (you will fi nd this listed separately before the letter A). Then start fi rst
time operation with OK.
Daily operation
Switch on/off
Your TV is equipped with an eco-standby power supply unit. On standby the
power consumption drops to low power (see page 32). If you want to save
even more electricity, switch the set off with the ON/Off button. However,
please bear in mind that EPG data will be lost and programmed timer
recordings will not be performed by the TV.
Switching off
If the TV set is switched on, you can switch it to
standby using the blue ON/OFF button of the
remote control.
The red lamp on the TV set lights up. If it lights green and
red, a timed recording is made, EPG data is entered or
radio operation without screen display is active.
Switching on the TV set
From standby it is best to switch back on with the blue
On/Off button or with a numeric key (station 0 – 9) of the
remote control.
Or switch on the TV set with OK, you can see the station
table and select a station.
Switching the radio function on
With the RADIO button on the remote control.
Radio mode is only possible if the TV set is equipped for
satellite reception
or an external radio receiver is connected to the
AV connections AV1, AV2 ...
If you switch off the TV set with the ON/OFF button on the right of the set,
the display no longer light up.
First installation
OK
OK
OK
RADIO
PIP
32398_020 Xelos A32_37_Buch.indb 1032398_020 Xelos A32_37_Buch.indb 10 10.02.2005 11:09:51 Uhr10.02.2005 11:09:51 Uhr