Filter
Top Products
33
Network Connectivity
Network Connectivity
The SG17L7584 Observation System can be remotely controlled using your existing network and
the provided NetViewer software.
OBSERVATION SYSTEM
ROUTER
(Not Included)
PC
(Not Included)
INTERNET
1. Connect the Observation System to
the Router using the supplied
Ethernet Cable. Power the
Observation unit on. You may need
to tilt the monitor forward to access
the Ethernet Port.
NOTE: The Observation System
must be connected to the router
prior to powering on the system.
This allows the system to
communicate on your network
2. Set up a web account at http://
DDNS.strategicvista.net. Refer to
Pages 35 - 36 for setup and
configuration instructions.
3. Install the NetViewer software on
your PC. See Page 33 for
installation requirements, and refer
to the provided ‘NetViewer Guide’
with your product for details on
using the software.
4. Find the IP address of your
Observation using the Lorex IPEdit
application. See Page 37 for details
5. Enable PORT FORWARDING on
your Router. Refer to the
instructions on Page 38 for details.