Filter
Top Products
80
What are the recommended tips when setting up my system? - Appendix #10
What are the recommended tips when setting up my
system? - Appendix #10
There are several tips outlined below that will assist you in setting up your system:
Connecting and Mounting Cameras:
1. Connect the DIN Extension Cable to an open
channel port on the back of the System. Make
sure that the ARROW on the cable is pointing
up. This will align the pins on the cable
correctly with the port on the stem, preventing
the pins from becoming bent and the cable
from becoming inoperable.
2. Connect one of the provided Cameras to the
DIN Extension cable. Confirm that the arrows
on the DIN Camera Cable and the DIN
Extension cable are pointed together when
connecting the cable. If the pins in the DIN
Cable are bent, the Camera will NOT function
3. Mount the camera to the desired surface (ceiling, wall, shelf, etc.). Connecting the cables
BEFORE permanently mounting the stand will help prevent issues with cable length (camera is
mounted too far from the system and cannot be connected).
4. Aim the camera at the desired location. Remember to REMOVE THE PROTECTIVE FILM from
the lens of the camera by pulling on the plastic tab.
Navigating within the System Menu
• Enter the MENU screen by pressing the MENU
button. Enter the password (if required), and
select the SYSTEM SETUP option.
• The Setup Menu controls the System Settings,
Recording Settings and Archive.
• Scroll through the options by pressing the UP, DOWN,
LEFT and RIGHT buttons on the Front Panel or Remote Control.
• To enter a sub-menu, navigate to the option
and press the ENTER button. To exit a
SUBMENU, press the RETURN button.
• To exit the MAIN MENU, press the RETURN
button.