Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Transportation Instructions
72-Inch Cabinet Site Preparation and Installation Guide 21
Transportation Instructions
WARNING Risk of bodily harm. Failure to follow this procedure could result in a
cabinet becoming very unstable up/down inclines or over uneven surfaces.
To maximize stability during the transportation of a 72-inch cabinet, the center of gravity
for the cabinet must be as close to the base as possible. For this reason, it is recommended
that you transport the unit with the upper half of the modules depopulated. All heavier
weighted components in the upper half of the cabinet should be taken out and transported
by static protective means. This includes drives, battery canisters, and controllers.
It is not necessary to remove components in the rear of the modules, such as power
supplies. These components will not disturb an optimal center of gravity. If the original
shipping boxes are available, these may serve as ideal transportation for these components.
Here are some guidelines to follow:
•
Make note of the Tray ID settings for the drive modules. It is imperative that the drives
be replaced in the exact slots from which they were removed. Make sure the drives are
in the same order during shipping and that the drives have been associated with the
proper Tray ID.
•
If any cables need to be disconnected, note the cable configuration for future assembly.
The module’s user guide will help by providing cabling diagrams.
•
Keep all components from the same modules together.
•
All components must be replaced to the same module and location. This will avoid
conflicts and data loss.