Filter
Top Products
34 Rerecording (Tape Duplication)
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• Different brands of equipment may
operate differently.
• Make sure all connections are
secure. Otherwise, you may not
record both picture and sound.
• Audio and video cables are not
included.
Helpful Hints
5
Point the TV/VCR remote control at the TV/VCR. Press
the SPEED button until the desired tape speed (SP, LP,
or SLP) appears on-screen.
2
The source unit (VCR or camcorder) will play your tape. Insert a
prerecorded tape in the source unit. If playback begins, press
the STOP button on the unit.
3
The TV/VCR will record your tape. Insert a blank tape in the
TV/VCR. Make sure the tape’s record tab is intact. The TV/VCR
power will turn on automatically.
4
Point the TV/VCR remote control at the TV/VCR. Press
the COMBI button, then press Number buttons 0, 0 so
that A/V IN appears on-screen.
6
Press the PLAY button on the source unit and the
REC(ord)/OTR button on your TV/VCR at the same time.
Copying will begin.
7
To stop copying, press the STOP/EJECT button on the
TV/VCR, then stop the tape on the source unit (VCR or
camcorder).
1
Make the connections shown above, using audio and video
cables. (Make sure the source unit is connected to a
power source.)
ANT.
L
R
AUDIO IN
VIDEO IN
CH3
CH4
OUT
IN
ANT
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
VIDEO IN
AUDIO IN
L
R
ANT.
AUDIO/VIDEO IN Jacks
on the rear of TV/VCR
AUDIO/VIDEO OUT
Jacks on VCR
Use a Video cable to connect the VIDEO
OUT Jack on the VCR to the VIDEO IN
Jack on the rear of the TV/VCR.
Use an Audio cable to connect the AUDIO OUT Jacks on
the VCR to the AUDIO IN Jacks on the rear of the TV/VCR.
CCZ196comb.QX33 4/6/99 7:05 PM Page 34