Filter
Top Products
Hooking Up The TV/VCR (cont’d) 7
ANT.
L
R
AUDIO IN
VIDEO IN
CH3
CH4
OUT
IN
ANT
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
VIDEO IN
AUDIO IN
L
R
ANT.
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is
bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
• Audio and video cables are not supplied.
• A stereo audio cable (not supplied) is used here to deliver audio to the TV/VCR’s left and right channels.
Helpful Hints
Crooked Pin
Straight Pin
Bent pin
Plug
Cable
Hooking Up Your
TV/VCR to Another
Video Source
(VCR or Camcorder)
You may need this connection
if you want to copy tapes.
Details are on page 34.
AUDIO/VIDEO IN Jacks
on the rear of TV/VCR
AUDIO/VIDEO OUT
Jacks on VCR
Use a Video cable to connect the VIDEO
OUT Jack on the VCR to the VIDEO IN
Jack on the rear of the TV/VCR.
Use an Audio cable to connect the AUDIO OUT Jacks on
the VCR to the AUDIO IN Jacks on the rear of the TV/VCR.
2
Plug in the TV/VCR.
3
Before you turn on the TV/VCR, go to page eight.
D.
CCZ196comb.QX33 4/6/99 7:04 PM Page 7