Filter
Top Products
MTS Broadcast Stereo System 55
Your TV/VCR can receive a program broadcast in stereo or with second audio (usually, that means a pro-
gram is broadcast with a second language).
When the second audio is available, you can select either the main audio (Mono) or the second audio. But
your TV/VCR can record only the sound you select. Select a sound by following the steps on page 56.
NOTE: When a program is broadcast in stereo, the TV/VCR can record only in monaural (single-source) sound,
regardless of your selection.
When you play back a tape, you will hear only the sound recorded on a tape, regardless of your sound
selection.
Read the information on this page to familiarize yourself with your TV/VCR’s stereo and second audio
setups. Then, follow the directions on page 56 to receive a program broadcast in stereo or second audio.
Understanding On-Screen Displays
When you receive a signal from a channel you’re watching, portions of the on-screen display shown below
will appear when you press the STATUS/EXIT button on the remote control.
Specifically…
When a program is broadcast in stereo, STEREO appears here.
To watch in stereo, select STEREO at step 3 on page 56.
NOTE: When you record a program broadcast in stereo, the TV/VCR can record
only in monaural sound, regardless of your selection.
When a program is broadcast in second audio, SAP appears here. To
watch or record in second audio, select SAP at step 3 on page 56.
When a program is available both in stereo and second audio, both
STEREO and SAP appear here. If so, you may select STEREO, MONO,
or SAP at step 3 on page 56.
The indication STEREO or SAP that appears on this side of the status display
tells you if the program you’re watching is available in stereo or second audio.
This indication is not available during tape playback.
When a program is not available in stereo or second audio, the indication
MONO appears.
12:00 AM STOP
CH10
STEREO/SAP
SLP M 1:23:45
12:00 AM STOP
CH10
STEREO/SAP
SLP M 1:23:45
CCZ196comb.QX33 4/6/99 7:05 PM Page 55