Filter
Top Products
37EN 37EN
Recording
Basic SetupConnections Playback EditingIntroduction Function Setup Others
Español
TIMER RECORDING
Checking, canceling, or correcting the timer
programming information
If the timer program did not complete correctly,
the error number appears in the timer pro-
gramming list.
1) Press [STANDBY-ON
y
y].
2) Press [TIMER].
3) Check the information on the list you will need.
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
1. JAN/01 12:57AM 1:57PM 8 HQ
Date Start End CH Mode
4) To clear the timer programming:
Use [K / L] to select the program, then press
[CLEAR].
To correct the timer programming:
Use [K / L] to select your desired program, then
press [OK].
Next, correct the timer programming by using
[K / L / { / B]. Finally, press [OK] again.
5) Press [TIMER] to exit.
6) Press [STANDBY-ON
y
y] to return to the timer
standby mode.
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
*
JAN/01 12:57AM 1:57PM 8 E22
Date Start End CH Mode
Press [CLEAR] to erase the selected program.
Each error number means:
E1-22
E37-39
Recording error other
than below
E41 Power failed
E24 Unrecordable disc E42 No disc when
recording
E25-26 Copy prohibited
program
E43 Already 49 titles
recorded
E29 Disc protected E44 Already 254 chapters
recorded
E30 Disc full E45 Copy prohibited
program
E35 PCA full E46 It is impossible to
record additionally
on a disc recorded
by other units when
setting “Replace Disc
Menu” to “OFF”.
E36 Already finalized
video format disc
E40 Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
• E23, E27, E28, E31, E32, E33 and E34 are not displayed.
• A program with the error number is grayed and
asterisked in the timer programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
Press [STOP C] on the front panel of the unit.
[STOP C] on the remote control is not effective.
Note
• Press [TIMER] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case,
you cannot select any other program.
To stop the timer recording in process