Filter
Top Products
6 Hooking Up the TV/VCR
Hook up your TV/VCR using one of the
connections shown.
Connect a Cable TV
signal or an antenna to
the ANT(enna) Jack.
Hooking Up Your TV/VCR With a
Cable Box/Satellite Receiver
To view any channel, set the TV/VCR to
the Cable Box/Satellite Receiver output
channel (channel 03 or 04). Then, select
channels at the Cable Box/Satellite
Receiver.
Connect the
Cable TV/Satellite
_signal to the IN
Jack on the Cable
Box/Satellite
%: f:::;:_,,:_ Receiver.
Connect an RF
_ _" coaxial cable
II
(not supplied) to
....... _# the OUT Jack on
the Cable Box
...............[..........:,_ or Satellite
Receiver and to
the ANT(enna)
Jack on the
TVNCR.
C
Hooking Up Your TV/VCR With the
Supplied Rod Antenna
To install the supplied rod antenna, push
the stem of the antenna into the antenna
hole at the top on the rear of the
TV/VCR. Connect the antenna wire to the
ANT(enna) Jack on the rear of the
TV/VCR as shown. Extend the antenna
and adjust its length, direction, and angle
for the clearest picture.
Rod Antenna
(supplied)
Plug the AC power cord into an AC power
outlet.
Follow the steps on page eight when you
turn on the TVNCR for the first time.
i