Filter
Top Products
32 Rerecording (Tape Duplication)
• If you connected another VCR to
the AUDIO/VIDEO IN jacks on the
back of VCR 2, press 0, 0, 1 at
step 5. L1 will appear on the TV.
• If you connected another VCR to
the AUDIO/VIDEO In jacks on
front of VCR 2,press 0, 0, 2 at
step 5. L2 will appear on the TV.
• When the VCR is set to L1 or L2,
the screen is blue.
• Unauthorized recording of copy-
righted TV programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws. A copy-pro-
tected program will not record
clearly.
• Audio and video cables are not
supplied.
• If you have the MVR440MG/17
or MVR450MG/17, connect one
audio cable to the AUDIO OUT
jack on VCR1 and to the AUDIO
IN jack on VCR2.
Helpful Hints
ANT
AUDIO
VIDEO
IN
OUT
OUT IN
OUT
L
R
IN
ANT
AUDIO
VIDEO
IN
OUT
OUT IN
OUT
L
R
IN
VCR 1
Playing VCR
VCR 2 Recording VCR
1.Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2.Video cable from VIDEO OUT Jack of VCR
1 to VIDEO IN Jack of VCR 2
3. RF coaxial cable
from the OUT
jack of VCR 2 to
the TV’s ANTEN-
NA IN Jack
1
Make the connections shown above.
2
VCR 1 will play your tape. Insert a prerecorded tape
in VCR 1. If the tape does not have a record tab, play
begins. If this happens, press STOP/EJECT on VCR 1 once.
3
VCR 2 will record your tape. Insert a blank tape in
VCR 2. Make sure the record tab is intact (see page five).
Make sure VCR 2 is on and in VCR position. (The green
VCR/TV light will appear. If it does not, press VCR/TV once.)
4
Turn on the TV and set it to channel 3 or 4 (the RF
output channel of VCR 2). See page seven.
5
Point the remote at VCR 2. Press 0, 0, 1 or 0, 0, 2. (See
Helpful Hints at right.)
6
Point the remote at VCR 2. Use SPEED to select SP
or SLP.
7
Press PLAY on VCR 1 and RECORD on VCR 2 at the
same time.
8
To stop recording, press STOP/EJECT on VCR 2
once, then stop the tape on VCR 1.
These instructions show you how to copy tapes using two
MVR650MG/17 VCRs.
Different VCRs may operate differently.