Filter
Top Products
ANT
AUDIO
VIDEO
IN
OUT
OUT IN
OUT
L
R
IN
7
5
A
N
T
/
C
A
B
L
E
AUDIO
R
L
VIDEO
OUT
IN
IN
OUT
OUT
IN
ANT
75
ANT /
CABLE
RF coaxial cable
Antenna or
Cable TV
signal
Hookups: No Cable Box/Satellite (cont’d) 7
ANTENNA IN Jack
(on back of TV)
example only
3
Connect the RF coaxial cable (supplied) to the OUT Jack on the back of the VCR and to
the Antenna In jack on the TV. (You may use either a snap-on type (supplied) or screw-on type,
whichever you prefer.)
4
Plug in the AC power cords of the TV and the VCR.
5
Set the TV to channel 3. This is the VCR’s preset RF output channel.
If you cannot use channel 3 at your TV, use channel 4 instead. To change the VCR’s output channel to
4, press and hold PLAY on the VCR for three seconds during tape play. The VCR’s RF output channel
will alternate between 3 and 4 each time you do this. There is not a channel 3/4 switch on the VCR.
You must change the RF output channel as described.
● If the RF output channel does not change, stop tape play, then start play again.Try again to press
and hold PLAY on the front of the VCR for three seconds during tape play.
● If the power fails or if you unplug the VCR’s power cord for more than 30 seconds, the RF output
channel will return to channel 3.
6
You are ready to turn on the VCR. Please go to page 11 for directions before turning on
the VCR.