Filter
Top Products
36 Time Search
Time Search lets you go to a specific point on a tape. Enter the
amount of time you wish to skip in order to reach the specified
point. Make sure:
● The VCR is on and is in VCR position. (The VCR/TV light will
appear. If it does not, press VCR/TV once.)
● There is a tape in the VCR.
1
Press SEARCH MODE until TIME SEARCH appears.
• You can set a Time Search for up
to 9 hours, 59 minutes (9:59).
• Time Search is not available dur-
ing recording.
• To exit Time Search mode, press
CLEAR.
• To cancel a Time Search in
progress, press STOP.
• If the end of the tape is reached
during a Time Search, the VCR will
cancel the search and rewind the
tape. See page 38.
Helpful Hints
2
Within 30 seconds, press PLAY or STOP repeatedly
until your desired length of time appears. Or, press and
hold PLAY or STOP until you reach the length of time.
3
Within 30 seconds, press REW or F.FWD. The VCR
begins rewinding or fast forwarding to the specified point.
The time counts down on the screen beneath TIME SEARCH
as the searching progresses.When the tape finishes rewinding
or fast forwarding, the VCR will start play automatically.
CH
321
654
987
0
POWER
STATUS
SLOWREC MEMORY
SPEED
SEARCH MODE STILL/PAUSE
VCR/TV EJECT
M
EN
U
CLEAR
REW
PLAY
STOP
F.FWD
1
2-3
TIME SEARCH
- :- -
TIME SEARCH
2 :5 0
TIME SEARCH
2 :5 0
D