Filter
Top Products
5
ENGLISH
FOREWORD
This section must be read carefully before any connection
is made to the mains supply.
WARNINGS
• Do not expose the equipment to rain or moisture.
• Do not remove the cover from the equipment.
• Do not insert anything into the equipment through
the ventilation holes.
• Do not cover the ventilation holes with any items
such as tablecloths, newspapers, curtains, etc.
• Do not place naked flame sources, such as lighted
candles, on the equipment.
• Do not handle the mains lead with wet hands.
• Allow adequate ventilation. Leave a gap of 0.1m
on all sides of the unit.
• Do not splash or spill water on the unit. Do not
place objects filled with liquid (such as vases) on
the unit.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product complies with the household power
and safety requirements in your area.
IMPORTANT: (FOR UK VERSION ONLY)
This apparatus is fitted with an approved moulded 13 Amp
plug. To change a fuse in this type of plug proceed as follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5A,
A.S.T.A or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value
of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
NOTE: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accordance
with the following code:
BLUE - “NEUTRAL” (“N”)
BROWN - “LIVE” (“L”)
1 The BLUE wire must be connected to the terminal
which is marked with the letter “N” or coloured BLACK.
2 The BROWN wire must be connected to the terminal
which is marked with the letter “L” or coloured RED.
3 Do not connect either wires to the earth terminal in the
plug which is marked by the letter “E” or by the safety
earth symbol or coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the two wires.
PRECAUTIONS
The following precautions should be taken when operating
the equipment.
GENERAL PRECAUTIONS
When installing the equipment ensure that:
– the ventilation holes are not covered.
– air is allowed to circulate freely around the equipment.
– it is placed on a vibration free surface.
– it will not be exposed to excessive heat, cold,
moisture or dust.
– it will not be exposed to direct sunlight.
– it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.
If a foreign object or water does enter the equipment,
contact your nearest dealer or service center.
Do not pull out the plug by pulling on the mains lead; grasp
the plug.
It is advisable when leaving the house, or during a
thunderstorm, to disconnect the equipment from the mains
supply.
COMPACT DISCS
The glossy side shining like a rainbow is the front side of the
disc, and the side on which the label is printed is the back.
Unlike conventional turntables for playing analogue discs, the
DH9300 Music Server reads the information recorded on the
disc from underneath without contacting it using a beam of
laser light. Therefore, the performance of a compact disc will
not degrade like conventional analogue records.
Handle discs carefully so as not to damage or scratch
the front side.
To protect the disc avoid placing it in the following
locations:
– In direct sunlight or near a source of heat like a heater.
– In a place which is damp or dirty.
– In a place which could be exposed to rain, such as
near a window.
Always keep the surface of the disc clean.
Up to six billion data units are recorded on the front side of
the disc. When cleaning the disc surface always be sure to
use a special compact disc cleaner. Do not use a
conventional record cleaner for analogue records, as this
will adversely affect the disc surface.
Store discs properly by placing them in their disc cases.
Do not attach a piece of paper or sticker on the label
side of the disc.
When a disc has a piece of plastic tape or rental CD label
with paste protruded from the edge or when a disc has a
trace of such a sticky object, do not attempt to play the
disc. If such a disc is inserted into the Music Server it may
cause extensive damage to the system. It may also be
impossible to remove the disc.
Do not use a disc with a special shape.
Do not attempt to use a disc with a special shape such as a
heart-shaped disc or octagonal disc. This may cause the
system to malfunction.
DTS encoded discs
Caution - when playing DTS encoded CDs excessive noise
will be heard on the analogue outputs jacks of the Music
Server. To avoid possible damage to the audio system you
should ensure that the correct connections are made to your
amplification system for replaying this type of disc.
CAUTION
When disposing of used batteries, please comply with
governmental regulations or environmental regulations
or environmental public instruction’s rules that apply in
your country or area.
POWER BUTTON
When this button is pressed once, the power turns On
and information will appear on the display. When
pressed again, press the Off action key or the 3 key on
the remote control to switch to Off mode.
When the unit is in Off mode the “Standby” indicator is
lit; the apparatus is not disconnected from the AC mains
supply in this mode.