67
DTV
STB
VCR/
TV
DVD/
CATV
POWER
A
ENTER
MENU
VOL CH
AV MODE
MUTE
INPUT
ANT-A/B
DISPLAY
FLASHBACK
ENT.
PLAY
FF
REW
PA
USE
S
T
OP
RE
C
DDF
C
CH
INP
UT
VIEW
M
O
D
E
TWIN
PI
C
T
U
R
E
V
C
R
/
DV
D
P
O
WE
R
Q
-SOUN
D
TITLE
BCD
C
H
/S
KI
P
PERSONAL PREFERENCE
DTV STB BRAND
REMOTE CONTROL
CODE NUMBER
Panasonic
Pioneer
RCA
Sharp
Sony
04
01
02
01
03
Operation of the Remote Control for Other Devices (Continued)
How to Identify a DTV STB (Digital TV Set-Top Box)
■ To Identify Your DTV STB –Direct Entry Method
Use the following steps and the list below to quickly find the remote control code
for your DTV STB.
• First look up your DTV STB’s remote code number on the list below before
continuing the direct code entry steps below.
(1) Press
DTV/
STB
and the button lights.
(2) While holding down
DISPLAY
, press on your remote control.
Make sure
DTV/
STB
lamp goes out and then release both buttons.
(3) Within ten seconds after releasing
DISPLAY
and , enter your DTV STB’s
two-digit code number using
DIRECT ACCESS
( ~ ) (refer to the list).
The code should be identified within two minutes.
•
DTV/
STB
lights for two seconds and then goes out. This indicates that the setting is
performed successflly.
• The remote control is now ready to send commands to your DTV STB.
Note
• Depending on the model, year produced, brand, and type of DTV STB, some
models may not be compatible with the remote control.
Identifying your DTV STB through the Search method
(1) While pointing the front part of the remote control towards the infrared sensor
of the DTV STB, press
DISPLAY
and then and hold them down for up to
two minutes. Be careful not to let the DTV STB scan more than five channels
when the indicator starts to increase. If you continue to hold down the
buttons after five channel scans, the proper remote code can be passed up
and the two-minute cycle will have to be repeated.
• The remote control then searches in order for the DTV STB Brand Code
Number (listed below).
(2) At the instant when the DTV STB channel changes, release
DISPLAY
and
and the procedure will be completed. If a channel change does not occur on
the DTV STB within two minutes, read the identifying instructions again and
repeat the steps. Should a channel change still not occur, the remote will
most likely not operate your DTV STB.