Filter
Top Products
68
DTV
STB
VCR/
TV
DVD/
CATV
POWER
A
ENTER
MENU
VOL CH
AV MODE
MUTE
INPUT
ANT-A/B
DISPLAY
FLASHBACK
ENT.
PLAY
FF
REW
PA
USE
S
T
OP
RE
C
DDF
C
CH
INP
UT
VIEW
M
O
D
E
TWIN
PI
C
T
U
R
E
V
C
R
/
DV
D
P
O
WE
R
Q
-SOUN
D
TITLE
BCD
C
H
/S
KI
P
PERSONAL PREFERENCE
Operation of the Remote Control for Other Devices (Continued)
How to Identify a Cable Converter
■ To Identify Your Cable Converter –Direct Entry Method
Use the following steps and list (on page 69) to quickly find the remote control
code for your cable TV converter.
• First look up your converter’s remote code number on page 69 before
continuing the direct code entry steps below.
(1) Press
DVD/
CATV
and the button lights.
(2) While holding down
DISPLAY
, press on your remote control.
Make sure
DVD/
CATV
lamp goes out and then release both buttons.
(3) Within ten seconds after releasing
DISPLAY
and , enter your converter’s
two-digit code number using
DIRECT ACCESS
( ~ ) (refer to the list
on page 69). The code should be identified within two minutes.
•
DVD/
CATV
lights for two seconds and then goes out. This indicates that the setting
is performed successfully.
• The remote control is now ready to send commands to your converter.
Note
• Depending on the model, year produced, brand, and type of CATV converter, some
models may not be compatible with the remote control.
Identifying your Cable Converter through the Search
method
(1) While pointing the front part of the remote control towards the infrared sensor
of the cable converter, press
DISPLAY
and then and hold them down for up
to two minutes. Be careful not to let the cable converter scan more than five
channels when the indicator starts to increase. If you continue to hold down
the buttons after five channel scans, the proper remote code can be passed
up and the two-minute cycle will have to be repeated.
• The remote control then searches in order for the cable converter Brand
Code Number (listed on page 69).
(2) At the instant when the cable converter channel changes, release
DISPLAY
and and the procedure will be completed. If a channel change does not
occur on the cable converter within two minutes, read the identifying
instructions again and repeat the steps. Should a channel change still not
occur, the remote will most likely not operate your cable converter.