Filter
Top Products
73
Try a new channel, if OK, then possible station trouble.
Is Rear Projection TV plugged in? Power at outlet?
Is Rear Projection TV’s POWER button on?
Is antenna connected to terminal on the back of the set?
If outside antenna is being used, check for broken wire.
Check for local interference or external electrical noise.
Turn off with POWER button and then turn it on after
about a minute.
Adjust COLOR control.
Adjust PICTURE control.
Check external Video/Audio products; look for loose / broken
connections cables. (Refer to page 70.)
Check the batteries of Remote Control.
Are audio cables connected firmly? Check the volume level.
Is SP ON? See page 29.
Change Closed Caption mode to “OFF” / Energy Save
mode to “OFF”.
Unplug the Rear Projection TV and plug it in again after 2 minutes.
QUICK SERVICE CHECK LIST
POSSIBLE REMEDY
PROBLEM
No Playback of VCR and DIsk Player
No Picture or Sound from External Video/Audio Products
Remote Control Does not Work
Bars On Screen
Picture Distorted
Picture Rolls Vertically
No Color
Poor Reception on Some Channels
Weak Picture
Lines or Streaks in Picture
Ghosts in Picture
Picture Blurred
Sound OK, Picture Poor
Picture OK, Sound Poor
No Picture or Sound
Dark and Blank Picture
External Electrical Noise Interfering with TV
’s Operation
XXXXXXXXXXXXXXXXX
X XXXXXXXXXXXXXX XX
X X XXXXXXXXXXXXX XX
XXXXXXXXXX X X X X X XX
XXXXXXXXXXXXXX X XX
XXXX X X X X X XXX XXXXX
X X XXXXXXXXXXXXX XX
XXXXXXX XXXXXXXXXX
XXXXXXXXX XXXX XXXX
XXXXXXXXXXXXXXXXX
XXX XXXXXXXXXXXXXX
XXXXXXXXXXXXXXX XX
XXXXXXXXXXXXXXX XX
XXXXXXXXXXXXXXXX X
XXX XXXXXXXXXXXXXX
Before Calling for Service
Check these items and see if you can correct a problem with a slight adjustment of the controls.
Note
• When viewing in TEXT mode, if no TEXT broadcast is being received, the screen may
become dark and blank. Should this occur, set the Closed Caption mode to “OFF”.
• If your TV does not work normally in case of a power failure, turn the power off and then
turn the power on again.
(Dark and Blank Picture)