Filter
Top Products
39
ENGLISH
67 8
PAG E
123
4
LEARN
123
4
PAG E
123
4
3 Press the > button y to display the fourth
page CLONE menu.
4 Press the D3 (TX) direct button t.
The transmitting side is now ready.
5 Hold down the M button r of the receiving
remote control for three seconds or more.
The menu is displayed.
6 Press the > button y to display the fourth
page CLONE menu.
7 Press the D1 (RX) direct button t.
The receiving side is now ready.
8 Press the OK cursor button @0 on the
receiving remote control.
9 Press the OK cursor button @0 on the
transmitting remote control.
When copying is started, the bar indicators on both
LCDs start to move from the left to the right.
• When the copying operation is completed, TX
OK is displayed on the LCD of the transmitting
remote control, and RX OK is displayed on the
LCD of the receiving remote control.
• Do not touch either of the remote controls during
the copying operation. Doing so could cause
copying to fail.
• If the copying fails in the middle of the copying
process, RX ERROR is displayed on the
receiving remote control. Check and perform
steps 1 to 7 again.
• Copying takes about three minutes to complete
when the transmitting remote control has been
programmed to 100% capacity.
10 Once copying is completed, press the M
button r on both remote controls.
Copying by Source
The 12 sources can be copied on a source by
source basis. You can select from up to 12
source types.
<Receiving remote control>
03.10.6, 4:19 PMPage 39