Marantz UD7006 Blu-ray Player User Manual


 
41
Basic versionSimple version Information
ENGLISH
Advanced version
Audio Setting
Settings for audio output are made.
Audio Output
Default settings are underlined.
Set the audio output.
Setting items Setting details
Coaxial
For selecting the format
output from the digital audio
output terminals.
Bitstream : For selecting if the device connected to the unit supports
Dolby Digital or DTS Digital Surround.
PCM : For selecting when the device connected to the unit does not
support Dolby Digital or DTS Digital Surround.
Off : For outputting no audio signal from the digital audio output terminal
of the unit.
For converting audio signals, see “About digital signal audio output”
(vpage52).
HDMI
For selecting the format
output from the HDMI
output terminals.
Bitstream : For selecting when the device connected to the unit supports
Dolby TrueHD/Dolby Digital Plus/Dolby Digital or DTS-HD/DTS Digital
Surround. The output format is automatically selected according to the
audio format or the number of channels supported by the connected
HDMI device.
PCM : For selecting when a device connected to the unit does not support
Dolby TrueHD/Dolby Digital Plus/Dolby Digital or DTS-HD/DTS Digital
Surround.
Off : For outputting no audio signal from the HDMI output terminal of the
unit.
For converting audio signals, see “About digital signal audio output”
(vpage52).
NOTE
• If “BD Audio Mode” is set to “HD Audio
Output” with MODE on the remote control, BD
secondary audio and interactive audio are not
output.
• For playback of a super audio CD with DSD via
the analog audio output terminals, set “HDMI”
to “Off”.
Setting items Setting details
Down Sampling
For selecting the sampling
rate output from the digital
audio output terminal.
Refer to the operation manual for the device connected to the unit, and
make settings depending on the connected device.
48 kHz / 96 kHz / 192 kHz
NOTE
• For rights-protected content, the audio signal is down-sampled to 48
kHz, 16-bits, and output.
• If the connected device does not support the sampling rate of 96 kHz or
192 kHz and the settings for the unit is made as 96 kHz or 192 kHz, much
noise may be generated from the connected device.
• When you want to view content that has a sampling frequency of 48 kHz
or higher with 2 ch Audio Out, set “Audio Output” – “Down Sampling”
in the GUI menu to “192 kHz”.
DRC
Compresses the dynamic
range of Dolby TruHD/Dolby
Digital Plus/Dolby Digital
Audio.
Off : Dynamic range is not compressed.
On : Dynamic range is compressed.
Auto : Dynamic range of Dolby TrueHD audio is automatically compressed
according to the material. Audio of Dolby TrueHD only is compressed.
This setting compensates high volume to low and low volume to high
when high volume is not desired at night.
Remote control operation
buttons
Displaying the menu
Cancel the menu
Move the cursor
(Up/Down/Left/Right)
Decision the setting Return to previous menu