Filter
Top Products
Manual # 26-0301000-00 / Revision C MatrixPRO 12x - 12 Input Matrix Switcher 31
MatrixPRO
TM
Remote Commands
HELP Capabilities. Send list of commands available back in ASCII format
ALVL num lvl Input Audio Level.
AVTYPE mode AV Type. 0=A/V, 1=Audio, 2=Video
CLEAR Clear all matrix video and audio routings.
CSUMSTAT Display Main Code/RBF Checksum info
FDLY dly Field delay for RGB sync. Delay (dly) in milliseconds
FPLOCK en Locks/unlocks Front Panel control
GCLEAR grp Clears grouping information
GADD grp out in Add output, input to group
GDEL grp out in Remove output, input from group
IPCONFIG I3 I2 I1 I0 IP address configuration I3.I2.I1.I0
LOADRMP Places unit into loader mode for firmware upgrade
OMUTE out en Enable/disable audio mute on output.
OSTAT [out] Displays output status in ASCII.
PSTAT [num] Displays preset status in ASCII.
PRST num Saves current front panel configuration to a Preset location.
RPRST num wr_flash Recall preset from a Preset location.
RNOV Recall Flash settings
RESETMP op Reset the MatrixPRO and recall saved Flash values op [R|F] Reset | Factory Reset
RTEMP out in audio Route inputs to outputs. If output is in group, group is routed too.
SBAUD Sets Baud Rate. 0=19200, 1=28800, 2=38400, 3=57600.
SMODE mode [485id] Serial Mode. 0=RS232, 1=RS485. [485id] opt if RS232
SWITCH mode Switching Mode. mode = 0(RGB) 1(VSync) 2(Comp) 3(VREF In)
TAKE en en = 1 simulates a TAKE button pushed on the front panel (i.e takes all prelim routes and
makes it permanent). en = 0 simulates a CANCEL button pushed
UNOV Save current settings to FLASH
VDLY dly Vertical Interval delay. Delay for # of VSYNCs seen before raising /CE. Minimum is 1, max
is 255