Filter
Top Products
34 MatrixPRO 12x - 12 Input Matrix Switcher Manual # 26-0301000-00 / Revision C
Parameters: out - Output number; [1 - 8]
mte - Mute status; [0|1], Disable|Enable
Query:
OMUTE? out
Returns the selected output mute status in the format:
=mte
Example: OMUTE 2 1 (Mute output 2.)
Command:
OSTAT out
Description: Displays output information (i.e. which input video/audio # routed, audio level, etc).
Parameters: out - Output number; [1 – 8]
(Note: this parameter is optional, if no parameter exist, all output information (i.e. 1-8) will be
displayed.
Example: OSTAT 1 (Displays output status for output 1.)
OSTAT (Displays output status for all outputs.)
Command:
PSTAT out
Description: Displays preset information (i.e. preset valid, which input video/audio # routed, audio level, etc).
Parameters: out - Preset number; [1 – 16]
(Note: this parameter is optional, if no parameter exist, all preset information (i.e. 1-16) will be
displayed.
Example: PSTAT 1 (Displays preset status for preset 1.)
PSTAT (Displays preset status for all presets.)
Command:
PRST num
Description: Saves current front panel configuration/routing to a Preset location
Parameters: num - Preset number to save to; [1 – 16]
Example: PRST 1 (Saves configuration to preset location 1.)
Command:
RPRST num wr_flash
Description: Recall an existing preset from a preset location and update current front panel configuration/routing
If no preset information has been saved to the preset location, no changes are made. If wr_flash
bit is enabled, then the recall becomes the start up configuration.
Parameters: num - Preset number to recall from; [1 – 16]
wr_flash – Enables recall to become start up configuration [1|0]
Example: RPRST 1 0 (Recalls configuration from preset location 1 and doesn’t become start up
configuration.)
Command:
RESETMP op
Description: Resets the system to factory defaults
Parameters: op - Reset operation; [R|F], Restart|Factory
Example: RESETMP F (Resets system to factory defaults and resets all user saved presets.)
Command:
RTEMP out in audio
Description: Routes input to output. If the output is in a group, all the outputs in the group will be routed to the
input specified. If the output is in a I/O group but the input is not in the group, the command will be
ignored.
Parameters: out - Output number; [1 - 8]
in - Video Input number to route video; [1-12] / 101 if no input to add / 0 unroutes input
audio - Audio Input number to route audio; [1-12] / 101 if no audio to add / 0 unroutes input