Filter
Top Products
40 MatrixPRO 12x - 12 Input Matrix Switcher Manual # 26-0301000-00 / Revision C
MatrixPRO 12x Technical Specifications
Video Routing
Gain.....................................................Unity into 75 ohm load
Coupling…………………………………DC
Bandwidth ...........................................375 MHz (-3dB) @ 0dBm, fully loaded (One input driving all outputs)
0-25MHz +/- .1dB, 25-300MHz +1.5dB -.5dB @ 0dBm
Crosstalk........…………………....…… -80dB @ 1 MHz, -60dB @ 10 MHz, -50dB @ 30 MHz, -30dB@ 100 MHz
Switching speed..................................100 us to 4 seconds (Programmable)
Video Input
Number/signal type .............................12 RGBHV, RGBS, RGsB, RsGsBs, analog HDTV, component, composite,
S-video
Connectors ..........................................12 x 5 are female
Minimum/maximum levels....................Analog–0.5V to 1.85V p-p with no offset
Impedance........................................... 75 ohms
Return loss ........................................ -30dB @ 5 MHz
Maximum DC offset (Vin=1Vpp).....… +1.8V, -.6V
Video Output
Number/signal type ............................ 4 or 8 RGBHV, RGBS, RGsB, RsGsBs, analog HDTV, component, composite,
S-video
Connectors.......................................... 4 or 8 x 5 BNC female
Maximum level.................................... 2.85V p-p with limited BW, 0dBm for 375MHz BW
Impedance........................................... 75 ohms
Return loss.......................................... -30dB @ 5 MHz
DC offset............................................. ±125mV maximum with input at 0V offset
Switching type...................................... RGB Delay up to 4 seconds
Sync
Input type............................................. RGBHV, RGBS, RGsB
Output type.......................................... RGBHV, RGBS, RGsB
Input level ............................................0.5V to 5.0V p-p, 2.5V p-p normal
Output level (min).................................2.0-V p-p into 75 ohm load, 4V p-p no load
Input impedance.....................………...75 ohms
Output impedance............................... 75 ohms
Polarity................................................. Positive or negative (follows input)
VREF Sync
Input type............................................. VSync
Output type.......................................... VSync, Channel 1 VSync, Channel 1 Green VSync (Extracted)
Input level ............................................0.5V to 5.0V p-p, 2.5V p-p normal
Output level (min).................................2.0-V p-p into 75 ohm load, 4V p-p no load
Input impedance.....................………...75 ohms
Output impedance............................... 75 ohms
Polarity................................................. Positive or negative (follows input)
AUDIO — AUDIO MODELS ONLY
Audio Routing
Gain..................................................... -76dB to +20dB
Frequency response ........................... 20 Hz to 20 kHz, @2V
p-p
with 0.03% THD+N
Noise ................................................... 0.03% @ 1 kHz at rated maximum output drive
S/N ...................................................... >75dB, balanced, at 2V
rms
Crosstalk / Stereo Separation.............. <-88dB @ 1 kHz, fully loaded
Audio Input AUDIO MODELS ONLY
Number/signal type ..............................12 stereo, balanced/unbalanced
Connectors ......................................….12 3.5 mm captive screw connectors, 5 pole
Impedance............................................10 kohm balanced or unbalanced, DC coupled
Maximum level......................................6V
rms
at 0.3% THD+N