Filter
Top Products
INSTALLING THE UNIT UNDER A CABINET
The suggested mounting position of the unit is under a wall cabinet, but it can be installed under many areas. There should
be at least 2-1/2” distance between the unit and the wall to allow for connections and ventilation.
6
INSTALLATION
Cut the template and place inside the cabinet with the
template border marked “FRONT” along the front edge of
the cabinet, then use adhesive tape to fix the template. Drill
four 1/4” diameter holes as shown on the template. Remove
template when finished.
1
Measure the height of the cabinet bottom and overhang.
If the cabinet bottom is 1” thick, then the spacers are not
necessary, use screws only as shown.
2a
If the cabinet bottom is 3/4” thick, then use the spacers
turned upwards as shown.
3
If the cabinet bottom is 3/8” to 1/2” thick, then use the
spacers turned downwards as shown.
4
With a screwdriver (not an electric screwdriver or drill), fasten the
four screws into the spacer holder holes (or fasten the screw to
your set if spacers were not needed). Start screwing at two
opposite corners of the unit for better support.
5
Push the release latch, pull down the screen to a maximum
of 180° and rotate.
6
I
MPORTANT NOTES:
• Since the unit is rather heavy, be careful while mounting.
• To reduce risk of fire, do not place any heating or cooking
appliance beneath the unit, especially while the LCD screen
is open.
• Mount the unit so that its AC adapter can be plugged directly
to a wall outlet.
• Do not use a converter or extension cord.
•
Install the unit as far as possible from a source of noise; i.e.,
a refrigerator, microwave oven, fluorescent lamp, etc.
• Please allow ample space on each side for the speakers.
• Keep unit away when drilling to avoid getting wood
shavings in the ventilation holes.
• Drill from bottom up if there is not enough room in the
cabinet.