Filter
Top Products
58
The TV set will normally detect the colour standard
(PAL, SECAM, NTSC, NTSC44, PAL60, PAL M)
automatically.
If this automatic selection does not provide satis-
factory results (which should happen only rarely),
you can select the colour standard manually for
each programme position.
The colour standard is set in the factory to "Auto-
matic".
Setting the colour standard
• Press the "MENU" key to open the TV menu.
• Press the white key to open the
station table.
• Press the F2 key to enable editing of
the station table.
• Use the cursor control key to select
the programme position whose colour
standard you wish to change.
• Press the cursor control key ̈ to
move to the left column.
• Use the corresponding numeric key
(in the example:
´) to select
"Colour standard".
• Use the
-
+
key to select the desired colour stan-
dard, or to step through the available colour
standards until the picture is displayed clearly.
• Press the "OK" key to confirm your selection.
• Press the "EXIT" key to close the TV menu.
Opening the menu
22.1 Setting Stations
Colour standard for analogue stations
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
0076TF3
0075TF2
0074TF1
0073TV France
0072RTL 2
0071RTL
0070SAT 1
0069Bayern 3
0068ZDF
0067ARD
Colour standard SECAM
: select
:go to the
settings
Sound corrections
Colour standard
Picture quality
Picture correct.
Enter logo
Frequency/channel
OK
MENU
F2
EXIT
ᕥ
OK