Mitsubishi Electronics 148 Series Flat Panel Television User Manual


 
50 5. TV Menus
Inputs Menu
Inputs Menu Options
Name
Cable Box, Camcorder, CD/
Audio, DVD (DVD, DVD2,
Blu-Ray), DVR, Game (Game,
PS, Xbox, Wii), MP3 Player, PC,
Satellite, VCR, AVR
On/Off (ANT 1 and ANT 2 only)
Delete (deactivated HDMI only)
Control On, Control Off
(CEC-
enabled HDMI devices; operates
only when Inputs > NetCommand
HDMI Control is set to
On
)
Lets you assign or change names of inputs appearing in the •
Input Selection menu.
Press - to move between inputs.
Press - to select a name.
Lets you turn • Ant-1 and Ant-2 On/Off (to display/hide in Input
Selection menu).
Lets you delete unused HDMI inputs from the • Input Selection
menu.
If you change the name of an input after performing NetCom-•
mand “learning,” the IR codes you “learned” are erased.
General Notes
When you change an input name in the Name menu and then exit the Name menu:
The name is changed•
The icon in the • Input Selection menu is changed
Audio and video settings are changed to the defaults for the new device type.•
All previous NetCommand “learning” for the input is erased.•
Notes for HDMI devices
Disconnecting an HDMI device:• When you disconnect an HDMI device, the icon remains in the Input Selection
menu until you remove it. Select Delete in the Inputs > Name menu to remove an unwanted icon for an HDMI input.
NetC• ommand for HDMI and CEC-Enabled Devices:
If CEC conflicts occur, turn off CEC signals in one of
these ways: a) Turn off all NetCommand for HDMI signals from the TV (Inputs > NetCommand HDMI Control
menu), b) Turn off NetCommand HDMI signals for specific devices (Inputs > Name menu), or c) Turn off each
device’s internal CEC capability. See Appendix E for the TV’s NetCommand for HDMI Control or, to turn on/off
a specific device’s response to CEC signals, see the device’s owner’s manual.
•
Names of CEC-enabled devices: CEC-enabled devices send their own predefined name to the TV. You
cannot change the name of a CEC-enabled device; applies only when Inputs > NetCommand HDMI Control
is set
to
On
.
Order
Lets you put frequently used icons at the start of the Input Selection menu.
Press 1. to highlight the icon to move.
Press 2.
ENTER
to confirm the selection.
Press 3. to drag the icon to the desired position.
Press 4.
ENTER
to set the new position.
Learn
Sets up or changes NetCommand IR control of the current viewing device.
See detailed instructions in chapter 6, “NetCommand IR Control.”
AVR
Sets up NetCommand IR control of an A/V receiver.
See detailed instructions in chapter 6, “NetCommand IR Control,” starting on page 60.
Guide
Guide, Devices, Zip
Code
246 Series TV.
See Appendix D for the TV Guide Daily system.
NetCommand
HDMI Control
On, Off Select On or Off to enable or disable the TV’s control of all CEC-enabled
devices. See Appendix E for details.
To turn CEC on or off for individual devices, use the Inputs > Name
menu.