Mitsubishi Electronics LT-40151 Flat Panel Television User Manual


  Open as PDF
of 94
 
6. NetCommand Control of an A/V Receiver 59
IMPORTANT
To hear audio sent from the TV to the A/V receiver,
you must have:
Physically connected the TV to the A/V receiver •
via the analog or digital audio output.
Assigned, if needed, the name AVR if using an •
HDMI A/V receiver.
“•
Learned” the IR codes for the A/V receiver
inputs.
Assigned the TV’s audio output to the correct •
input in the NetCommand Inputs > AVR menu.
Selected the A/V receiver as the audio source. •
Press MORE then 9 (AUDIO), then
to show
the Speakers option,
then
to select the A/V
Receiver.
Setting Up A/V Receiver Control
Power and Volume
PerformthissetuptocontroltheA/Vreceiverpower
andvolumewiththeTV’sremotecontrol.
Toperformthissetupyouneed:
TheremotecontrolsforboththeTVandthe•
A/Vreceiver.
AnIRemittercableavailablefromMitsubishi.•
Before You Begin
ConnectyourA/VreceivertotheTVandanyaddi-
1.
tionaldevices.See“SettingUpTVInputs,”page12
and“TVConnections,”page16.
ConnecttheIRemittercabletotheTVandposition
2.
theIRemitterwhereitcansendsignalstotheA/V
receiver.See“IREmitterPlacement,”page53.
Setthe
3.
TV’sremotecontrolto
TV
modeusingthe
sidebutton.
Setup to Control A/V Receiver Power and Volume
Openthe
1.
Inputs >AVR screeninoneoftwoways:
Ifusingthe• New Device Foundscreenforthe
A/Vreceiver,highlightNetCommandandpress
ENTER
toopentheAVRscreen.
IfperformingNetCommandsetupatanytime•
afterAutoSensing:
Press
MENU
,highlightInputs,andhighlightAVR
toopentheAVRmenu.
Thefirstfunctionhighlightedinthe
2.
AVRscreenis
alwaysPower.AimtheTV’sremotecontrolatthe
TVandpress
ENTER
tobeginlearningforPower.
Inputs > AVR screen. Perform
NetCommand IR “learning” for A/V
receiver power and volume keys.
Whenthe
3.
Powertextstartsflashing,aimtheA/V
receiver’sremotecontrolattheTVandholdthe
POWER
or
POWER ON
keyuntilacheckmarkappears
nexttoPower.
Ifthetextstopsflashingbeforethecheckmark•
appears,repeatthisstep.
ToremovethekeyfromNetCommandcontrol,•
pressthe
CANCEL
keywhilethekeynameis
highlighted.
Pressthe4. keyontheTV’sremotecontroltohighlight
otherkeysinthelist.Repeatsteps2and3foreachaddi-
tionalfunctionyouwishtocontrolthroughNetCommand.
IftheA/Vreceiverhasaseparate
5.
POWER OFF
key,
press ontheTV’sremotetohighlightPower Off.
Repeatsteps2and3to“learn”the
POWER OFF
key.
If the device has no
POWER OFF
key, skip this step.
Whenfinished“learning”thepowerandvolume
6.
keys,either
TowatchTV,press•
BACK
.
TocontinuewithNetCommandsetuptocontrol•
switchingofA/Vreceiverinputs,highlight
NEXTandpress
ENTER
.
 previous next