Mitsubishi Electronics LT-40151 Flat Panel Television User Manual


  Open as PDF
of 94
 
74 Appendices
Ifpromptedforaname,
4.
highlightthenameyouwant
toassignthedevice.
Highlight
5.
On.
Highlight
7.
EXITandpress
ENTER
toclosetheNew
Device Foundscreen.
Note: AtanytimeaftercompletingAutoInputSens-
ing,youcansettheTV’sHDMIcontrolonoroff
intheInputs > HDMI Controlmenu.
153 Series.
8.
TosupplementHDMIcontrolwith
NetCommandIRcontrol,seepage52.
ManynewHDMIdeviceshaveafeaturecalledCon-
sumerElectronicsControl(CEC)orHDMIControl.
HDMIControlallowsonedevice,suchastheTV,to
controlotherdevices,suchasanA/Vreceiverordisc
player.UseofCECisoptional.
EachmanufacturerchooseswhichCECfunctionsto
supportsoitisdifficulttopredictwhichdevicesand
featuresarecompatiblewithMitsubishi’sHDMIControl.
YoumayfindthatCECfunctionsforaspecificdeviceare
limited.
To use HDMI Control, you must enable it in both
the TV and the device.
In the TV.• EnableHDMIcontrolfromtheNew
Device FoundscreenorfromtheInputs > HDMI
Controlmenu.
I•
n the Device.MostdeviceswithHDMICECcom-
patibilityletyouturnitonoroffinthedevicemenus,
whereitistypicallylistedas“HDMIControl.”
Enabling HDMI Control of CEC Devices
Toensureproperdetection
PoweronHDMIdevicesbeforeconnectingthemto•
theTV.
ConnectandsetupHDMIdevicesoneatatime.•
Poweronthedeviceandallowittocompletethe
1.
power-onsequence(bootup).Stopanyplayback.
ConnectthedevicetooneoftheTV’sHDMIinputs.
2.
WhentheTVdetectstheconnection,the
3.
New
Device Found screenwillappear.
Note: See“IftheNewDeviceFoundScreenDisplays
NoHDMIControlOption”onthispageifthereis
noHDMIControloption.
New Device Found screen with HDMI Control option.
This screen displays only if the device’s HDMI Control is
enabled
.
Appendix C: HDMI Control of CEC Devices
If the New Device Found Screen
Displays No HDMI Control Option
IftheNew Device Foundscreenshowsnooptionfor
HDMIControl,oneoftheseconditionsapplies:
HDMI Control is turned off in the menus of the •
new device
Action:
Highlighta. EXITandpress
ENTER
toclosethe
New Device Foundscreen.
Displaythedevice’ssetupmenusandenableb.
thedevice’sCECcapabilities.
WaitfortheTV’sc. New Device Foundscreen
toappearagain.
Ifthed. New Device Foundscreendoesnot
appear,poweroffthedevice.Poweronthe
deviceandwaitfortheNew Device Found
screentodisplaywiththeHDMIControl
option.
The device does not have CEC compatibility•
Action:
Controlthedevicewithitsownremote-
controlorprogramtheTV’sremotecontrolto
operatethedevice.
153 Series.- UsetheTV’sNetCommandIR
control(page52).
 previous next