Mitsubishi Electronics OD62 TV Mount User Manual


 
2 - 3 2 - 3
MELSEC-Q
2 SYSTEM CONFIGURATIONS
(b) Mounting to a MELSECNET/H remote I/O station
The table below shows the network modules and base units applicable to
the QD62 (E/D) and quantities for each network module model.
Depending on the combination with other modules or the number of
mounted modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the
modules.
Base unit
2
Applicable network
module
3
No. of mountable
modules
1
Main base unit of
remote I/O station
Extension base unit of
remote I/O station
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
Up to 64
: Applicable, : N/A
1 Limited within the range of I/O points for the network module.
2 Can be installed to any I/O slot of a base unit.
3 The coincidence detection interrupt function is not supported.
REMARK
The Basic model QCPU or C Controller module cannot create the MELSECNET/H
remote I/O network.
(2) Support of the multiple CPU system
When using the QD62 (E/D) in a multiple CPU system, refer to the following
manual first.
• QCPU User's Manual (Multiple CPU System)
(a) QD62(E/D) supporting the multiple CPU system
There are no restrictions on the function version of the QD62(E/D) .
(b) Intelligent function module parameters
Write intelligent function module parameters to only the control CPU of the
QD62(E/D).