Mitsubishi Electronics PAR-30MAA Universal Remote User Manual


 
– 12 –
[3]Room temperature display
[4]Auto mode display setting
(6) Auto mode setting
(7) Administrator password setting
(8) Language selection
[Button operation]
Move the cursor to the “Room temp.” on the display details setting screen, and select the desired setting with the F3 or F4 button.
(The factory setting is “Yes”.)
· Yes: Room temperature appears on the Main display.
· No: Room temperature does not appear on the Main display.
Note: Even when “Yes” is set, the room temperature is not displayed on the Main display in the “Basic” mode.
[Button operation]
Move the cursor to the “Auto mode” on the display details setting screen, and select the desired mode with the F3 or F4 button.
(The factory setting is “Yes”.)
· Yes: “AUTO COOL” or “AUTO HEAT” is displayed during operation in the AUTO mode.
· No: Only “AUTO” is displayed during operation in the AUTO mode.
[Button operation]
Whether or not to use the AUTO mode can be selected by using the F3 or F4 button. This setting
is valid only when indoor units with the AUTO mode function are connected.
(The factory setting is “Yes”.)
Press the SELECT button to save the changes made.
· Yes: The AUTO mode can be selected in the operation mode setting.
· No: The AUTO mode cannot be selected in the operation mode setting.
[Button operation]
[1] To enter the current Administrator password (4 numerical digits), move the cursor to the digit
you want to change with the F1 or F2 button, and set each number (0 through 9) with the F3 or
F4 button.
[2] Press the SELECT button.
Note: The initial administrator password is "0000." Change the default password as necessary to
prevent unauthorized access. Have the password available for those who need it.
Note: If you forget your administrator password, you can initialize the password to the default
password "0000" by pressing and holding the F1 and F2 buttons simultaneously for three
seconds on the administrator password setting screen.
[3] If the password matches, a window to enter a new password will appear. Enter a new password
in the same way as explained above, and press the SELECT button.
[4] Press the F4 button (OK) on the password change confirmation screen to save the change.
Press the F3 button (Cancel) to cancel the change.
Note: The administrator password is required to make the settings for the following items.
· Timer setting · Weekly timer setting · Energy-save setting
· Outdoor unit silent mode setting · Restriction setting
Refer to the Instruction Book that came with the remote controller for the detailed
information about how to make the settings for these items.
[Button operation]
Move the cursor to the language you desire with the F1 through F4 buttons.
Press the SELECT button to save the setting.
Auto mode
Auto mode Yes / No
Select:
Cursor
Administrator password
Enter administrator password
Select:
Cursor
Administrator password
Enter administrator password
Change administrator password.
Select:
Cursor
Administrator password
Enter administrator password
Update administrator password?
Cancel OK
Cursor
Select:
English
Deutsch
Italiano
Svenska
Français
Español
Português
Pycckий
Language selection
Cursor
WT05950X01_2_GB_A5.fm Page 4 Friday, October 1, 2010 9:01 AM