Filter
Top Products
10
Chapter
ANT- A
ANT-B
LOOP
OUT
Back Panel
COMPONENT
480i/480P/1080i
2
1
Y
Pr
Pb
AUDIO-
RIGHT
LEFT/
(
M
O
N
O
)
AUDIO-
V
H
DTV(YPbPr/GBRHV)
480i/480P/1080i
INPUT
2
1
AUDIO-
RIGHT
AUDIO-
LEFT/
(MONO)
VIDEO
S-VIDEO
M
O
N
I
T
O
R
OUT
MONITORLINK
TM
/DVI
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
1
2
3
4
5
6
DVI
1. ANT-A, LOOP OUT and ANT-B
ANT-A and ANT-B receive signals from VHF/UHF antennas or a cable system. LOOP OUT sends the ANT-A signal
out to another device, such as a cable box or VCR.
Note: LOOP OUT is disabled when Energy Mode is set to Low and the TV power is set to Off.
2. Monitor Out
The Monitor Output sends the TV audio and video signals (excluding component video, DTV video and MonitorLink)
to an A/V receiver or other equipment.
3. Inputs 1-2
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, laser disc player, or other A/V
device to the TV. With each input, you may connect to the S-VIDEO or VIDEO terminal but not to both.
4. Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video outputs, such as a DVD player,
DTV receiver or compatible Video Game System. Please see Appendix B, page 59, for signal compatibility.
5. DTV Input
This input is used to connect a DTV receiver or cable box and can be configured for HDTV component (YPbPr), or
RGB plus H&V. Please see Appendix B, page 59, for signal compatibility.
6. MonitorLink™/DVI
This is a Mitsubishi-exclusive proprietary digital interface for the display of high quality digital video signals from
Mitsubishi products such as the HD-5000 HDTV Receiver/Controller. All video signals, both analog and digital are
sent digitally to your Mitsubushi TV. Can also be used as a DVI (HDCP) input for other compatible sources.
Note: The DVI-HDTV input terminal is compliant with the EIA-861 standard. It is not intended for use with
personal computers or devices outputting video signals with computer resolution.
Back Panel Input/Output